Main Profile

At A Glance

How to Build a Dorm Room Air Conditioner

Watch more College Dorm Life Survival Guide videos: http://www.howcast.com/guides/58-College-Dorm-Life-Survival-Guide Subscribe to Howcast's YouTube Channel - http://howc.st/uLaHRS Learn how to build a dorm room AC with these simple steps. Howcast uploads the highest quality how-to videos daily! Be sure to check out our playlists for guides that interest you: http://howc.st/ytmainplaylists Subscribe to Howcast's other YouTube Channels: Howcast Health Channel - http://howc.st/HOE3aY Howcast Video Games Channel - http://howc.st/tYKKrk Howcast Tech Channel - http://howc.st/rx9FwR Howcast Food Channel - http://howc.st/umBoJX Howcast Arts & Recreation Channel - http://howc.st/vmB86i Howcast Sports & Fitness Channel - http://howc.st/vKjUjm Howcast Personal Care & Style Channel - http://howc.st/vbbNt3 Howcast empowers people with engaging, useful how-to information wherever, whenever they need to know how. Emphasizing high-quality instructional videos, Howcast brings you experts who provide accurate information in easy-to-follow tutorials on everything from makeup, hairstyling, nail art design, and soccer to parkour, skateboarding, dancing, kissing, and much, much more. Warning Always use extreme caution when using an electrical appliance near water. Step 1: Detach the fan covering Unplug the fan. Then, detach its face by lifting the latches, removing the hook, or using a screwdriver if necessary. Step 2: Attach copper tubing Coil the copper tubing from the outside edge to the center of the fan's face, attaching it every 6 inches with zip ties. Leave enough extra pipe at the center to bend down so it hangs past the outside edge. Trim the pipe with the hacksaw so it runs an inch or two past the edge of the face. Then, sand the rough edges of the copper tubing. Tip Use more copper tubing on the fan's face for a more efficient heat exchange. Step 3: Attach rubber tubing Cut the vinyl tubing into 4-foot sections using scissors. Then, attach them to either end of the copper tubing with hose clamps. Tighten the clamps with a flathead screwdriver. Reattach the fan face to the fan. Step 4: Set up buckets Fill one 5-gallon bucket with cold water and set it on a raised surface by the fan. Place one end of a vinyl tube at the bottom of the bucket and tape into place. Put the other bucket on the ground and take hold of the other end of the tube. Tip Use ice water for an even chillier AC. Step 5: Siphon and enjoy Gently suck on the tube like you would if it were a drinking through a straw. When water starts to flow, put the tube in the empty bucket, and tape it near the top. Plug the fan in and turn it on. Step 6: Keep it going When the raised bucket is empty, dump the lukewarm water from the bucket on the ground, add more cold water to the raised bucket, and repeat the process to keep your dorm nice and cool. Did You Know? Willis Carrier invited the air conditioner in the first decade of the 20th century.
Length: 02:16

Contact

Questions about How to Build a Dorm Room Air Conditioner

Want more info about How to Build a Dorm Room Air Conditioner? Get free advice from education experts and Noodle community members.

  • Answer

Ask a New Question